Comfort

One refreshed heater, it was a brown, crusted, sorry looking item, but for the price I cannot moan :)

Stripped down completely, motor stripped cleaned, core washed out - loads of crap in it, grit blasted, painted and ready to go...Also got my pedals and brackets coated. Just have to cut the circlip grooves in the ends of the pin and I can call this job done.


Tested the unit/motor and even without all the holes bunged up it blows alot of air, good!

Need some 1" grommets to fill the cable holes and tape up the pipe slots....there will not be any need for speedo and rev cable holes in the electronic age!

Also helps to run the fan blades as close to the flared hole as you can for maximum sucky sucky.